欧洲经济区联合委员会决定第114/2000号,修订关于原产地规则的欧洲经济区协议议定书4

技术法规类型:欧盟Eurlex法规 来源:tbtmap

EURLEX ID:22001D0222(06)

OJ编号:OJ L 52, 22.2.2001, p. 40-43

中文标题:欧洲经济区联合委员会决定第114/2000号,修订关于原产地规则的欧洲经济区协议议定书4

原文标题:Decision of the EEA Joint Committee No 114/2000 of 22 December 2000 amending Protocol 4 to the EEA Agreement on rules of origin

分类:11.40.10.10_欧洲自由贸易区(EFTA)国家

文件类型:外部关系 Decision|决定

生效日期:2001-01-01

废止日期:2058-12-31

法规全文:查看欧盟官方文件

EUR-Lex - 22001D0222(06) - EN

22001D0222(06)

Decision of the EEA Joint Committee No 114/2000 of 22 December 2000 amending Protocol 4 to the EEA Agreement on rules of origin

Official Journal L 052 , 22/02/2001 P. 0040 - 0043


Decision of the EEA Joint Committee

No 114/2000

of 22 December 2000

amending Protocol 4 to the EEA Agreement on rules of origin

THE EEA JOINT COMMITTEE,

Having regard to the Agreement on the European Economic Area, as adjusted by the Protocol adjusting the Agreement on the European Economic Area, hereinafter referred to as "the Agreement", and in particular Article 98 thereof,

Whereas:

(1) Protocol 4 to the Agreement was amended by Decision No 188/1999 of the EEA Joint Committee of 17 December 1999(1).

(2) Some technical amendments are in order to correct anomalies between the different language versions of the text.

(3) The list of insufficient working and processing needs to be amended to ensure proper interpretation and to take account of the need to include some operations not covered previously by this list.

(4) The need has arisen to provide for a system of accounting segregation of originating and non-originating materials, subject to authorisation by customs authorities.

(5) The provisions concerning the amounts expressed in euro need to be revised in order to clarify the procedure and to provide greater stability for the level of the amounts in national currencies.

(6) To take account of the lack of production of a certain material within the countries concerned, a correction must be made to the list of working and processing requirements which non-originating materials have to fulfil to qualify for originating status,

HAS DECIDED AS FOLLOWS:

Article 1

Protocol 4 to the Agreement shall be amended as follows:

1. Article 1(i) shall be replaced by:

"(i) 'added value' shall be taken to be the ex-works price minus the customs value of each of the materials incorporated which originate in the other countries referred to in Article 3 or, where the customs value is not known or cannot be ascertained, the first verifiable price paid for the materials in the EEA;"

2. Article 6 shall be replaced by:

"Article 6

Insufficient working or processing operations

1. Without prejudice to paragraph 2, the following operations shall be considered as insufficient working or processing to confer the status of originating products, whether or not the requirements of Article 5 are satisfied:

(a) preserving operations to ensure that the products remain in good condition during transport and storage;

(b) breaking-up and assembly of packages;

(c) washing, cleaning; removal of dust, oxide, oil, paint or other coverings;

(d) ironing or pressing of textiles;

(e) simple painting and polishing operations;

(f) husking, partial or total bleaching, polishing, and glazing of cereals and rice;

(g) operations to colour sugar or form sugar lumps;

(h) peeling, stoning and shelling of fruits, nuts and vegetables;

(i) sharpening, simple grinding or simple cutting;

(j) sifting, screening, sorting, classifying, grading, matching (including the making-up of sets of articles);

(k) simple placing in bottles, cans, flasks, bags, cases, boxes, fixing on cards or boards and all other simple packaging operations;

(l) affixing or printing marks, labels, logos and other like distinguishing signs on products or their packaging;

(m) simple mixing of products, whether or not of different kinds;

(n) simple assembly of parts of articles to constitute a complete article or disassembly of products into parts;

(o) a combination of two or more operations specified in subparagraphs (a) to (n);

(p) slaughter of animals.

2. All operations carried out in the EEA on a given product shall be considered together when determining whether the working or processing undergone by that product is to be regarded as insufficient within the meaning of paragraph 1."

3. The following Article shall be inserted after Article 19:

"Article 19a

Accounting segregation

1. Where considerable cost or material difficulties arise in keeping separate stocks of originating and non-originating materials which are identical and interchangeable, the customs authorities may, at the written request of those concerned, authorise the 'accounting segregation' method to be used for managing such stocks.

2. This method must be able to ensure that, for a specific reference-period, the number of products obtained which could be considered as 'originating' is the same as that which would have been obtained if there had been physical segregation of the stocks.

3. The customs authorities may grant such authorisation, subject to any conditions deemed appropriate.

4. This method is recorded and applied on the basis of the general accounting principles applicable in the country where the product was manufactured.

5. The beneficiary of this facilitation may issue or apply for proofs of origin, as the case may be, for the quantity of products which may be considered as originating. At the request of the customs authorities, the beneficiary shall provide a statement of how the quantities have been managed.

6. The customs authorities shall monitor the use made of the authorisation and may withdraw it at any time whenever the beneficiary makes improper use of the authorisation in any manner whatsoever or fails to fulfil any of the other conditions laid down in this Protocol."

4. In Article 21, paragraph 1, first sentence, the following shall be inserted after "exporter":"hereinafter referred to as 'approved exporter',"

5. Article 30 shall be replaced by:

"Article 30

Amounts expressed in euro

1. For the application of the provisions of Article 20(1)(b) and Article 25(3) in cases where products are invoiced in a currency other than euro, amounts in the national currencies of the countries referred to in Article 3 equivalent to the amounts expressed in euro shall be fixed annually by each of the countries concerned.

2. A consignment shall benefit from the provisions of Article 20(1)(b) or Article 25(3) by reference to the currency in which the invoice is drawn up, according to the amount fixed by the country concerned.

3. The amounts to be used in any given national currency shall be the equivalent in that currency of the amounts expressed in euro as at the first working day of October. The amounts shall be communicated to the European Commission by 15 October and shall apply from 1 January the following year. The European Commission shall notify all countries concerned of the relevant amounts.

4. A country may round up or down the amount resulting from the conversion into its national currency of an amount expressed in euro. The rounded-off amount may not differ from the amount resulting from the conversion by more than 5 per cent. A country may retain unchanged its national currency equivalent of an amount expressed in euro if, at the time of the annual adjustment provided for in paragraph 3, the conversion of that amount, prior to any rounding-off, results in an increase of less than 15 per cent in the national currency equivalent. The national currency equivalent may be retained unchanged if the conversion would result in a decrease in that equivalent value.

5. The amounts expressed in euro shall be reviewed by the EEA Joint Committee at the request of the Contracting Parties. When carrying out this review, the EEA Joint Committee shall consider the desirability of preserving the effects of the limits concerned in real terms. For this purpose, it may decide to modify the amounts expressed in euro."

6. Annex II shall be amended as follows:

The entry for HS heading 5309 to 5311 shall be replaced by:

">TABLE>"

Article 2

This Decision shall enter into force on 1 January 2001, provided that all the notifications under Article 103(1) of the Agreement have been made to the EEA Joint Committee(2).

Article 3

This Decision shall be published in the EEA section of, and in the EEA Supplement to, the Official Journal of the European Communities.

Done at Brussels, 22 December 2000.

For the EEA Joint Committee

The President

G. S. Gunnarsson

(1) Not yet published in the Official Journal.

(2) No constitutional requirements indicated.

托管标准,您可以接收以下服务:

1 标准定期系统查新,若有最新版本,会以站内短信或邮件的形式通知用户;

2 随时在标准托管页面中查看到该条标准的最新状态;

3 若用户有在学习和科研中的需要,可以在标准托管页面中试阅标准;

4 企业如果需要上新产品,我院及时提供标准查询、采购等方面的支持;

5 为企业在标准制修订、企业良好行为创建以及标准化试点过程中遇到的困难,可联系我院指定相关专家负责进行指导帮助、提供政策咨询;

6 为企业提供标准化政策的解读、标准化知识的推广培训、标准自我公开声明、标准文献的免费查询、企业标准化体系建设等方面的标准化服务;

进入企业标准托管

您可以通过编辑查新模板,批量查询指定标准集的最新情况。我们会通过查询,向您展示您所查询标准的:

1. 准确的标准号及标准名称(我们通过人工智能技术对您提交的标准号进行自动纠正)

2. 标准的最新状态(现行、废止或未发布)

3. 若标准已废止并被新标准替代,会反馈被替代的标准

4. 若您已托管此标准,便可以实时跟踪这个标准的最新状态

标准查新 模板下载

您可以在这里检索全球超过140万条标准,支持上百个国内国际标准组织的标准查询。您也可以在这里检索国内各类国家、部委和地方的法律法规。

更多标准子库在持续建设中。

标准检索

标准资讯点击排行榜 全部

资讯标题点击

[[ n.title ]] [[ n.read ]]

大连标准化公共服务平台

版权:大连标准化研究院有限公司

地址:大连市中山区高原街56号

电话:0411-82740851

大连标准